TM 9-2320-289-20
12-4.
LUBRICATION.
WARNING
Dry cleaning solvent P-D-680 is toxic and flammable, Always wear
protective goggles and gloves and use only in a well-ventilated area. Avoid
contact with skin, eyes, and clothes and DO NOT breathe vapors, DO NOT
use near open flame or excessive heat. The solvent’s flash point is
100°F-138°F (38°C-59°C). If you become dizzy while using cleaning
solvent, immediately get fresh air and medical help. If solvent contacts
eyes, immediately wash your eyes with water and get medical aid.
After cleaning has been accomplished, wipe all grease fittings clean with dry cleaning
solvent (Item 15, Appendix C) and lubricate the truck in accordance with LO 9-2320-289-12. Remove
excess grease after lubrication and before processing.
12-5.
PRESERVATION.
a. All critical unpainted metal surfaces must be protected during shipment. Use
procedures and materials listed in paragraphs (1) and (2) below. If the preservatives listed are not
available, oil or grease specified in LO 9-2320-289-12 may be used for this purpose.
(1) Battery Leads. Disconnect both batteries. (See paragraph 4-38). Each battery
lead terminal, including the jumper lead ends, must be cleaned, coated with grease (Item 26,
Appendix C) and wrapped with tape (Item 48, Appendix C).
(2) Miscellaneous Preservation. Coat all unpainted, exposed, machined metal
surfaces on the exterior of the truck with corrosion preventive compound (Item 13, Appendix C).
12-6.
PACKAGING.
a. Lenses. Cover all truck lamp lenses with grease proof barrier material (Item 5,
Appendix C) and secure with tape (Item 48, Appendix C).
b. Electrical Openings. Cover all electrical receptacles with tape (Item 48, Appendix C)
or with plastic caps which will afford the same degree of protection.
12-7.
PACKING.
a. Pack all Basis Issue Items (BII) and Additional Authorization List (AAL) items to prevent
mechanical damage.
b. For shipment, disconnect both battery negative cables (see paragraph 4-38) and wrap
with tape (Item 48, Appendix C).
12-8.
MARKING.
Provide any necessary identification and precautionary markings in accordance with
instructions in MlL-STD-129.
12-4
