TM 9-2320-289-20
11-33. DOMELIGHT AND WIRING HARNESS REPLACEMENT (M1008 AND M1008A1)
(Cont).
12.
Remove grommet (19) and carefully pull wiring harness (12) into cargo box and remove. DO
NOT discard grommet.
13.
Remove electrical lead (3) from clips (21) at right bow roof support (4), right side of front roof
bow, and front section of roof support (1).
14.
Disconnect electrical lead (3) from domelight at connector (22) and remove electrical lead.
b.
INSTALLATION
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
NOTE
If installing domelight, perform steps 1-4 and 6.
If installing wiring harness (12) and electrical iead (3), perform
steps 5-13.
Install 2 bulbs (25) into base assembly (24).
Install clear lens (26) and blue lens (29) into cover plate (28) with clear iens to the front. Install
cover plate to base assembly (24) with 6 screws (27).
Install base assembly (24) to roof support bracket (30) with 4 screws (2).
Install roof support bracket (30) to 4 studs from roof supports (1) with 4 nuts (23).
Install electrical iead (3) to clips (21) at front section of roof support (1), right side of front roof
bow, and right bow roof support (4).
Connect electrical lead (3) to domelight at connector (22).
Connect electrical iead (3) to wiring harness (12).
Carefully push wiring harness (12) through hole in cargo box front. install grommet (19).
Install ground wire (10) to cargo bed using boit (7) and new locknut (8) (M1008), or install
ground wire (10) with communications rack ground strap to stud (11) with nut (9) (M1008A1).
Install wiring harness (12) to front of cargo box with 2 clamps (20), washers (5), and screws
(6) .
Install wiring harness (12) along frame and under hood with 5 clamps (13) and screws (14).
Carefully push wiring harness (12) through hole in left front of bulkhead and install grommet
(15).
Connect purple wire (18) to uDOME and orange wire (16) to T-LPS positions on fuse box
(17) under dash.
FOLLOW-ON TASKS:
Connect both battery negative cables. (See paragraph 4-38)
Check operation of domelight.
11-125