TM 9-2320-289-20
11-34. REAR DOOR ASSEMBLY MAINTENANCE (M1008 AND M1008A1) (Con’t).
NOTE
Latch assembly (19), handle assemblies (21 and 24), and window
assembly (26, 27, 28, and 29) can be replaced without removing door
assembly (6) from truck.
If disassembling handle assemblies (21 and 24), perform steps 1 and 2.
If disassembling latch assembly (19), perform steps 1 and 3 through 5.
If disassembling door frames (15), perform step 6.
If disassembling window assembly (26, 27, 28, and 29), perform steps 7
and 8.
1.
2.
3.
4.
5.
6.
7.
8.
Loosen setscrew and remove inner handle assembly (21).
Remove 3 screws (25) and outer handle assembly
assembly (6) by tapping them out if damaged.
Remove 8 screws (18) and 2 latch brackets (17).
Remove 4 screws (20) and latch assembly (19).
Remove 12 nuts (23) from rear door assembly (6)
(24). Remove 3 nuts (22) from rear door
by tapping nuts out if damaged.
Remove 14 screws (16) and 4 door frames (15).
At window assembly, remove 18 screws (26), retainer (27), and gasket (28). Discard gasket
only if worn.
Remove plastic window (29) from opening, Scrape off old RTV sealant from wood.
c.
ASSEMBLY
NOTE
If assembling window assembly (26, 27, 28 and 29), perform steps
1 and 2.
If assembling door frames (15), perform step 3.
If assembling latch assembly (19), perform steps 4-6.
If assembling handle assemblies (21 and 24), perform steps 7
and 8.
1.
Apply RTV sealant to wood at window opening.
2.
Install plastic window (29), gasket (28), and retainer (27) with 18 screws (26).
NOTE
1 door frame (15) is installed with 4 hinge screws.
3.
Install 4 door frames (15) to rear door assembly (6) with 14 screws (16).
11-128
