11-33. DOMELIGHT AND WIRING HARNESS REPLACEMENT (M1008 AND M1008A1)

11-33. DOMELIGHT AND WIRING HARNESS REPLACEMENT (M1008 AND M1008A1) (Cont).

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
729

TM 9-2320-289-20 11-33. DOMELIGHT AND WIRING HARNESS REPLACEMENT (M1008 AND M1008A1). This task covers: a. Removal b. Installation INITIAL SETUP: Equipment Condition Materials/Parts • Both battery negative cables disconnected. • One locknut (M1008) (See paragraph 4-38) a. REMOVAL 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. NOTE If removing domelight, perform steps 1-5. If removing 2 bulbs (25), 2 lenses (26 perform steps 4 and 5. If removing wiring harness (12) and steps 6-14. and 29), or cover plate (28), electrical lead (3), perform Remove 4 screws Remove 6 screws Remove blue lens assembly (24). (2) and roof support bracket (27) and cover plate (28). (29) and clear lens (26) from Disconnect electrical lead (3) from connector (22) at ceiling. Remove 4 nuts (23) and roof support bracket (30) from front and rear roof supports (1). (30) from base assembly (24). cover plate (28) and 2 bulbs (25) from base NOTE Tag wires for installation. Disconnect purple wire (18) from “DOME” and orange wire (16) from “T-LPS” positions on fuse box (17) under dash. Remove grommet (15) at bulkhead and carefully pull wiring harness (12) through bulkhead. Discard grommet if damaged. Remove 5 screws (14), clamps (13), and wiring harness (12) from under hood and along frame. Disconnect wiring harness (12) from electrical lead (3) at connector at front of cargo box. Remove 2 screws (6), washers (5), and clamps (20), and remove wiring harness (12) from front of cargo box. Remove screw (7) and locknut (8) from ground wire (10) (M1008), or nut (9) from stud (11), and remove ground wire (10) and communications rack ground strap (M1008A1). Discard locknut. 11-122

Privacy Statement
Press Release
Contact