TM 9-2320-280-34
22-10. AMBULANCE EXTERIOR BODY REPAIR (Cont'd)
28.
Install lower body panel (19) on body panels (1) with eight rivets (8), sixteen rivets (17), and forty-one
rivets (15).
29.
Position tail lamp housing bracket (2) on lower body panel (19) and body panels (1).
30.
Using tail lamp housing bracket (2) as a template, locate, mark, and drill thirteen 0.187-inch (4.75 mm)
diameter holes (4) in lower body panel (19) and body panels (1). Remove tail lamp housing bracket
(2).
31.
Apply approximately 0.125inch (3.175 mm) thickness of adhesive to tail lamp housing bracket (2),
lower body panel (19), and body panels (1)
32.
Install tail lamp housing bracket (2) on lower body panel (19) and body panels (1) with thirteen rivets
(6).
33.
Spot paint tail lamp housing bracket (2), litter stowage opening bracket (12), and body panels (1)
(TM 43-0139.)
34.
Apply wicking sealant to eighty-one rivets (13), (8), (17), (15), and (6) installed in steps 25, 28, and 32.
35.
Install tail lamp assembly CIM 9-2320-280.20).
36.
Install backup light assembly (TM 9-2320-280-20).
37.
Install battery ground cable (TM 9-2320-280-20).
38.
Install door weatherstrip (TM9-2320-280.20.)
22-29
