TM 9-2320-280-34
22-10.
AMBULANCE EXTERIOR BODY REPAIR (Cont'd)
f.
Left Rear Lower/Upper Body Panel Repair
1.
Remove door weatherstrip (TM 9-2320-280-20.)
2.
Scribe two lines (12) centered over twenty-one rivets (14) on rear lower/upper body panel (16). Extend
scribed lines (12) a minimum of 1.00-in. onto body panels (11).
3.
Using a 0.125-in. (3.175 mm) drill, remove ten rivets (14) from rear lower/upper body panel (16) and
body panels (11).
4.
Using a 0.187-in. (4.75 mm) drill, remove eleven rivets (18) from rear lower/upper body panel (16) and
body panels (11).
5.
Remove rear lower/upper body panel (16).
6.
Remove adhesive residue and clean body panels (11). Do not remove scribed lines (12) marked in step
2.
7.
Position rear lower/upper body panel (16) on body panels (11) and transfer scribed lines (12) marked in
step 2. Remove rear lower/upper body panel (16).
8.
Using scribed lines (12) marked in step 7, drill ten 0.125-in. (3.175 mm) diameter holes (13) in rear
lower/upper body panel (16).
9.
Using scribed lines (12) marked in step 7, drill eleven 0.187-in. (4.75 mm) diameter holes (19) in rear
lower/upper body panel (16).
10.
Apply approximately 0.125-in. (3.175 mm) thickness of adhesive sealant to rear lower/upper body panel
(16) and body panels (11).
11.
Install rear lower/upper body panel (16) on body panels (11) with ten rivets (15) and eleven rivets (17).
12.
Spot paint rear lower upper body panel (16) and body panels (11) (TM 43-0139.)
13.
Apply wicking sealant to eleven rivets (17) installed in step 11.
14.
Install door weatherstrip (TM 9-2320-280-20.)
22-27
