TM 9-2320-280-34
22-9.2. LEFT FRONT FLOOR PANEL R EPAIR (C nt'd )
o
3.
Cut metal strip (2) from sheet metal, and mark two reference lines (1), centerline (3), directional
arrow (4), and letter B on metal strip (2).
4.
Locate, mark, and drill twenty-six 0.187-in. diameter holes through metal strip B (2).
5.
Cut two metal strips (5) from sheet metal, and mark centerlines (7), directional arrows (6), and
letters C and D on metal strips (5).
6.
Place metal strip C (5) on a suitable work surface, with arrow (6) facing up and left.
7.
Locate, mark, and drill seven 0.187-in. diameter holes through metal strip C (5).
8.
Place metal strip D (5) on a suitable work surface, with arrow (6) facing up and left.
9.
Locate, mark, and drill fourteen 0.187-in. diameter holes through metal strip D (5).
22-16.6
Change 1
