TM 9-2320-280-34
18-4. TRANSFER CASE REPAIR (MODEL 242) (Cont'd)
43.
Install front output yoke (25) on shaft (23) with lockwasher (24) and nut (21). Tighten nut (21) to
90-130 lb-ft (122-176 Nm).
44.
Install driven gear (30), O-ring (29), and pinion adapter (28) in rear retainer (12) with clamp (27) and
capscrew (26). Tighten capscrew (26) to 12-15 lb-in. (1.4-1.7 Nm).
45.
Move shift range lever (22) to make sure transfer shifts into four detent positions. May have to
turn shafts to obtain full detent engagement.
FOLLOW-ON TASK: Install transfer case (para. 8-3).
Change 2
18-51/(18-52 blank)
