TM 9-2320-280-34
18-4. TRANSFER CASE REPAIR (MODEL 242) (Cont'd)
d. Assembly
1.
For general assembly instructions, refer to para. 2-16.
2.
Place thrust washer (3), input gear (5), thrust washer (3), and retainer (2) into low range gear (4)
with snapring (1). Make sure snapring (1) is fully seated in groove of low range gear (4).
_AUTION
C _____
Use correct tool to press input gear into ball bearing. Pilot bearing
could be moved out of position causing damage to equipment.
3.
Using driver handle and main pilot bearing installer and supporting ball bearing (12), press input
gear shaft (5) into ball bearing (12). Snapring groove must be exposed beyond ball bearing (12).
4.
Install snapring (8) in input gear shaft (5).
5.
Using input gear seal installer, install input gear seal (10) in bearing retainer (9).
6.
Run a bead of silicone compound on contact surface of bearing retainer (9).
7.
Install bearing retainer (9) on front half-case (6) with four screws (11). Tighten screws (11) to
12-20 lb-ft (16-27 Nm).
8.
Install shift sector (7) in front half-case (6).
9.
Install shift lever (15) on shift sector (16) with washer (14) and nut (13). Tighten nut (13) to
20-25 lb-ft (27-34 Nm).
10.
Install poppet (19), spring (18), O-ring (17.1), and shift detent plug (17) in bore (20). Tighten plug
to 12-18 lb-ft (16-24 Nm). Turn shift lever (15) so poppet (19) fits in teeth of shift sector (7).
18-44
Change 2