TM 9-2320-280-34
17-30. TRANSMISSION ASSEMBLY FROM SUBASSEMBLIES (4L80-e) (Cont' )
d
7.
Determine correct apply pin to be used from table below:
NOTE
* Apply pins are identified by the number of rings around small end of
apply pins.
* If necessary to change apply pin, refer to rear servo repair para. 17-
27.
a. If both flats are above gauge surface, use pin length #1.
b. If one flat is above gauge surface, use pin length #2.
c. If both flats are below gauge surface, rotate to side B.
d. If both flats are above gauge surface, use pin length #3.
e. If one flat is above gauge surface, use pin length #4.
f. If both flats are below gauge surface, rotate to side C.
g. If both flats are above gauge surface, use pin length #5.
h. If one flat is above gauge surface, use pin length #6.
i. If both flats are below gauge surface, use pin length #7.
8.
Remove checking tool and gauge pin.
