TM 9-2320-280-34
This task covers:
Inspection
INITIAL SETUP:
Applicable Models
Equipment Condition
M997A2, M1025A2, M1035A2,
Transmission disassembled into subassemblies
M1043A2, M1045A2, M1097A2, M1123
Manual References
Maintenance Level
TM 9-2320-280-24P
General support
Inspection
NOTE
Intermediate clutch plates, backing plate, and front band were
removed during disassembly. Inspect clutch plates only if they
will be reused.
Work area should be well-ventilated, clean, and free from
blowing dirt and dust.
Replaced damaged plates as a set.
Wave plate is used on 1997-1998 transmissions only.
1.
Inspect wave plate (4.1), four clutch plates (3), and clutch plate assemblies (4) for cracks, wear,
evidence of overheating and scoring.
2.
Inspect backing plate (1) for cracks, breaks, scoring, and evidence of overheating. Replace if
damaged.
3.
Inspect front band (2) for cracks, loose or damaged anchor or pin ends, and worn or burned
composition material. Replace if damaged.
1997 - 1998
1995 - 1996
Change 1
