TM 9-2320-280-34
This task covers:
a. Torque Converter
i.
Front End Play Check (Measured)
b. Holding Fixture
j.
Rear Unit End Play Check (Measured)
c. Speed Sensors
k.
Pump Assembly
d. Oil Pan and Filter Assembly
l.
Turbine Shaft and Overdrive Carrier Assembly
e. Control Valve Assembly (1995 - 1996)
m.
Forward Clutch Assembly
e.1.Control Valve Assembly (1997 - 1998)
n.
Direct Clutch Assembly
f. Front Servo
o.
Intermediate Clutch Assembly
g. Rear Servo
p.
Gear Unit Assembly and Rear Band
h. Parking Lock Pawl and Actuator Assembly
q.
Center Support Assembly
INITIAL SETUP:
Applicable Models
Special Tools (Cont'd)
M997A2, M1025A2, M1035A2,
Torx adapter (Appendix G, Item 28)
M1043A2, M1045A2, M1097A2, M1123
Gear unit remover/installer Appendix G, Item 44)
Tools
Personnel Required
General mechanic's tool kit:
One mechanic
automotive (Appendix G, Item 1)
One assistant
Dial indicator (Appendix G, Item 95)
Equipment Condition
Special Tools
Transmission prepared for disassembly
Transmission holding fixture (Appendix G, Item 29) (para. 7-10).
Transmission holding fixture base
General Safety Instructions
(Appendix G, Item 30)
Torque converter must be supported during removal.
Adapter (Appendix G, Item 41)
Slide hammer adapter (Appendix G, Item 32)
Maintenance Level
Oil pump remover/installer (Appendix G, Item 43) General support
a. Torque Converter
WARNING
Torque converter must be supported during removal and
installation. Failure to do this may cause injury to personnel or
damage to equipment.
NOTE
Be certain torque converter turns freely. Record any abnormal
looseness or noises.
Remove torque converter (2) from transmission (1).
17-63
