TM 9-2320-280-34
17-3. TRANSMISSION DISASSEMBLY INTO SUBASSEMBLIES (3L80) (Cont'd)
o. Intermediate Clutch
1.
Remove snapring (11) from intermediate clutch backing plate (12) and case (2).
2.
Remove backing plate (12), three clutch disks (13), and three steel clutch plates (14) from case (2).
Discard clutch disks (13).
p. Gear Unit
1.
Using 3/8 in. 12-point socket, remove center support-to-case aligning bolt (18) from case (2).
2.
Remove center support-to-case snapring (15) from case (2).
3.
Using gear unit holding tool, slide hammer adapter, and slide hammer, remove center support and
gear unit assembly (16) and rear case thrust washer (17) from case (2). Install thrust washer (17)
on center support and gear unit assembly (16).
Change 2
17-9
