TM 9-2320-280-34
11-5. STEERING GEAR REPAIR (Cont'd)
26.
Using spanner wrench, install adjuster plug (1) in housing (3). Do not tighten.
27.
Install locknut (2) over adjuster plug (1). Do not tighten.
28.
Install rack piston (4) and rack piston arbor into gear housing (3) so gear teeth on rack piston (4)
align with gear teeth on pitman shaft (5).
29.
Hold rack piston arbor tightly against rack piston (4) while turning stub shaft (6) clockwise.
Remove rack piston arbor.
30.
Install rack piston plug (7) into rack piston (4). Do not tighten.
31.
Center rack piston (4) and install pitman shaft (5) in housing (3).
Tighten rack piston plug (7) to 75 lb-ft (102 Nm).
32.
Change 1
