TM 9-2320-280-34
3-26. ENGINE PREPARATION (6.2 L AND 6.5 L) (Cont'd)
NOTE
Perform steps 7 through 13 for vehicles equipped with a 60 amp
alternator.
Prior to removal, tag all leads for installation.
7.
Remove two screws (6), lockwashers (7), and wire retaining strap (8) from alternator (22) and
remove wire retaining strap (8), spacer (9), and washer (10). Discard lockwashers (7).
8.
Remove two screw-assembled washers (1) from terminal cover (2). Discard screw-assembled
washers (1).
9.
Pry cover (2) away from waterproofing adhesive and remove cover (2).
10.
Remove waterproofing adhesive from around terminals (23).
11.
Disconnect lead 568A (14) from engine wiring harness (13).
12.
Remove capscrew (3), lockwasher (4), and ground 3B (5) from alternator (22). Discard lockwasher (4).
13.
Remove two nuts (26), lockwashers (25), washers (24), and leads 5A (12) and 2A (11) from
alternator (22). Discard lockwashers (25).
NOTE
There has been a change to the power steering lines support
bracket. Perform step 14 for vehicles with original configuration.
Perform step 15 for vehicles with new support bracket
configuration.
14.
Remove locknut (18), washer (19), capscrew (21), spacer (20), harness clamp (16), and clamp (17)
from support bracket (15). Discard locknut (18).
15.
Remove locknut (31), washer (32), capscrew (34), washer (33), harness clamp (28), and clamp (30)
from support bracket (29). Discard locknut (31).
1
2
NEW 6.2 L, 6.5 L
34
BRACKET
6
CONFIGURATION
3
5
7
28
26
4
8
33
9
29
25
30
10
24
31 32
11
21
12
15
16
13
14
23
EARLY 6.2 L
22
17
PRODUCTION
20
19
18
3-176
Change 2
