TM 9-2320-280-34
3-25. ENGINE INSTALLATION (6.5 L) (Cont'd)
143.
Install left splash shield (10) on bracket (11) with washer (9), capscrew (12), washer (9), and
locknut (8).
144.
Install harness and clamp (22) on splash shield (10) with screw (21) and assembled locknut (23).
145.
Install connector receptacle (19) on bracket (17) with four screws (18) and lockwashers (18.1).
Tighten receptacle cover (20).
146.
Install left splash shield (10) on airlift bracket (4) with washer (15) and capscrew (14). Tighten
capscrew (14) to 15 lb-ft (20 N.m).
147.
Install left splash shield (10) on airlift bracket (4) with washer (6), capscrew (13), washer (7),
washer (6), and locknut (5). Tighten capscrew (13) to 95-145 lb-in. (11-16 N.m).
148.
Install left splash shield (10) on support bracket (1) with washer (2), capscrew (16), washer (2), and
locknut (3). Tighten capscrew (16) to 6 lb-ft (8 N.m).
149.
Install right splash shield (38) on airlift bracket (4) with lockwasher (25) and screw (26).
150.
Install right splash shield (38) on airlift bracket (4) with washer (32), capscrew (34), washer (33),
washer (32), and locknut (31). Tighten capscrews (34) to 15 lb-ft (20 N.m).
151.
Install right splash shield (38) on support bracket (29) with washer (28), capscrew (30), washer (28),
and locknut (27). Tighten capscrew (30) to 15 lb-ft (20 N.m).
152.
Install fuel line clamp (37) on splash shield (38) with washer (36), capscrew (24), and locknut (35).
Tighten capscrew (24) to 15 lb-ft (20 N.m).
153.
Install bracket (41) on splash shield (38) with four washers (39), three capscrews (40), washer (39),
and nut (42).
154.
Install cover (44) on bracket (41).
155.
Install jack (45) on bracket (41) with two washers (46), spacers (47), and wing nuts (48).
156.
Install cover (44) on bracket (41) with two latches (43).
7
6
5
8
9
4
10
11
9
12
3
2
4
2
15
13
6
14
10
1
16
21
22
17
20
19
18
18.1
23
Change 2
