TM 9-2320-280-34
3 - 22. ENGINE REMOVAL (6.2L) (Cont' )
d
9.
Remove four screws (18) and connector receptacle (19) from bracket (17).
10.
Loosen rear receptacle cover (20) and slide wires of receptacle (19) out through slot in bracket (17).
11.
Remove nut and lockwasher assembly (24), screw (22), and harness and clamp (23) from
left splash shield (7). Discard nut and lockwasher assembly (24).
12.
Remove locknut (21), washer (14), capscrew (15), washer (14), and left splash shield (7) from
support bracket (16). Discard locknut (21).
NOTE
Early production vehicles used studs to connect splash shields to
airlift brackets.
13. Remove locknut (2), washer (3), washer (4), capscrew (11), and washer (3) from left splash shield (7)
and airlift bracket (1). Discard locknut (2).
14.
Remove capscrew (12), lockwasher (13), and left splash shield (7) from airlift bracket (1).
Discard lockwasher (13).
15.
Remove locknut (5), washer (6), capscrew (10), washer (9), and left splash shield (7) from
bracket (8). Discard locknut (5).
16.
Remove locknut (30), two washers (29), capscrew (31), and right splash shield (39) from support
bracket (28). Discard locknut (30).
17.
Remove locknut (32), washer (33), washer (34), capscrew (35), and washer (33) from right splash
shield (39) and airlift bracket (1). Discard locknut (32).
18.
Remove locknut (37), washer (36), capscrew (25), and fuel line clamp (38) from right splash
shield (39). Discard locknut (37).
19.
Remove screw (27), lockwasher (26), and right splash shield (39) from airlift bracket (1). Discard
lockwasher (26)
3-50
