TM 9-2320-280-34
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
______ _e _ renc __
Manual_R_fe____es
General mechanic's tool kit:
TM 9-2320-280-24P
automotive (Appendix G, Item 1)
TM 9-2815-237-34
Special Tools
Personnel Required
Engine lifting sling (Appendix G, Item 22)
One mechanic
One assistant
Materials/Parts
General Safety Instructions
Eight lockwashers (Appendix E, Item 104)
Direct personnel to stand clear during hoisting
operation.
Maintenance Level
Direct support
a. Removal
1.
Press air-release button (1) located at center of breather valve (2) before opening engine container
(5).
2.
Remove twenty-six nuts (19), washers (18), capscrews (16), and upper container (4) from lower con-
tainer (13).
3.
Position engine lifting sling on engine (6) and install on right cylinder head (23) with two capscrews
(24).
4.
Install sling bracket on left cylinder head (20) with two capscrews (22). Tighten capscrews (22) and
install sling bracket to engine lifting sling with pin (21).
5.
Remove four capscrews (14), lockwashers (8), and washers (7) from two engine mounts (12). Discard
lockwashers (8).
6.
Remove four capscrews (9), lockwashers (8), and washers (7) from two rear engine mounts (11).
Discard lockwashers (8).
WARNING
Direct personnel to stand clear during hoisting operation. Failure
to do this may cause injury to personnel.
7.
Attach hoist to engine lifting sling and remove engine (6) from lower container (13).
8.
Prepare engine for assembly (TM 9-2815-237-34).
b. Installation
WARNING
Direct personnel to stand clear during hoisting operation. Failure
to do this may cause injury to personnel.
1.
Attach hoist to engine lifting sling.
2.
Install engine assembly (6) in lower container (13).
3.
Install engine assembly (6) on two rear engine mounts (11) with four washers (7), lockwashers (8),
and capscrews (9).
4..
Install engine assembly (6) on two engine mounts (12) with four washers (7), lockwashers (8), and
capscrews (14).
5.
Remove pin (21) from sling bracket.
Change 2
