TM 9-2320-289-34
8-4.
POWER STEERING GEAR REPAIR (Con’t).
NOTE
Worm gear (32) and valve assembly (34) may come
(17), If so, separate adjuster plug from worm gear
9.
Using punch,
loosen and remove
locknut (18). Using spanner wrench,
remove adjuster plug (17).
out with adjuster plug
and valve assembly.
10.
Using a screwdriver at raised area,
remove
bearing
retainer
(19).
Remove thrust bearing spacer (20),
small upper bearing race (21 ), upper
thrust bearing (22), large upper
bearing race (23), and “O” ring (24).
Discard “O” ring.
11.
From rear side of adjuster plug (17), remove retaining ring (28). Press out needle bearing
(25), stub shaft seal (26); and stub shaft dust seal (27). Discard seals.
TA50487
8-18
