6-19. FRONT SPRING ASSEMBLY AND BUSHINGS REPLACEMENT (Cont)

6-19. FRONT SPRING ASSEMBLY AND BUSHINGS REPLACEMENT (Cont) - TM-9-2320-289-34_703

6-19. FRONT SPRING ASSEMBLY AND BUSHINGS REPLACEMENT (Cont) - TM-9-2320-289-34_705

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
687

TM 9-2320-289-34 6-19. FRONT SPRING ASSEMBLY AND BUSHINGS REPLACEMENT (Con’t). 5 . 6 . 7 . 8 . 9 . 10. 11. WARNING Spring assembly (2) is heavy. Use caution during installation. Failure to follow this warning may result in serious injury to personnel or damage to axle (1) assembly. If removed, install 2 bushings (12) to spring assembly (2) and drive in spacer (13). Position spring assembly (2) over axle (1). Install spring assembly (2) to hanger (21) with bolt (20), 2 washers (22), and new locknut (23). DO NOT fully tighten locknut. Connect spring assembly (2) to shackle (5) with bolt (3), washer (11), and new locknut (10). Tighten locknut (10) to 50 Ib.-ft. (68 N.m). Tighten locknut (23) to 90 Ib.-ft. (122 N.m). Position bottom spacer (18) on axle (1) housing. Raise axle, alining spring assembly (2) center bolt with hole in bottom spacer and axle housing. Install top spacer (17) alining bolt hole. NOTE Right side of all except Ml 009 uses only 1 “U” bolt (19), 2 nuts (15), and 2 bolts at anchor plate (14). Install 2 “U” bolts (19), 4 washers (16), and nuts (15). Install all nuts to uniform engagement on “ U“ bolts to retain and position anchor plate (14). NOTE All nuts (15) must be tightened evenly to ensure that “U” bolts (19) and spring assembly (2) seat properly. Tighten 4 nuts (15) in diagonal sequence to 25 Ib.-ft. (34 Nom). Fully tighten all nuts in same diagonal sequence to 150 Ib.-ft. (203 N.m). 6-128

Privacy Statement
Press Release
Contact