TM 9-2320-289-346-1.CONSTANT VELOCITY JOINT REPAIR (Con’t).b.CLEANING AND INSPECTION WARNINGDry cleaning solvent P-D-680 is toxic and flammable. Always wearprotective goggles and gloves and use only in a well-ventilated area. Avoidcontact with skin, eyes, and clothes and DO NOT breathe vapors. DO NOTuse near open flame or excessive heat. The solvent’s flash point is100°F-138°F (38°C-59°C). If you become dizzy while using cleaningsolvent, immediately get fresh air and medical help, if solvent contactseyes, immediately wash your eyes with water and get medical aid.1 .Clean front propeller shaft yoke, link yoke, and end of front propeller shaft (5) with drycleaning solvent.2 .Inspect ball seat insert bushing in front propeller shaft yoke (1) for wear. Replace frontpropeller shaft yoke if worn.3.Inspect centering ball stud for damage. Replace front propeller shaft (5) if damaged.c .ASSEMBLYCAUTIONEnsure that centering ball (15) is fully seated. Failure to follow this cautionmay result in damage to constant velocity joint,1. Place new centering ball (15) on stud.Drive new centering ball onto studuntil centering ball seats flush againstshoulder at base of stud. Apply a lightcoat of grease, provided in kit, tocentering ball.TA505086 - 3
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business