TM 9-2320-289-345-19.TRANSMISSION INTERMEDIATE CLUTCH, CENTER SUPPORT ASSEMBLYAND GEAR UNIT, AND REAR BAND MAINTENANCE.This task covers:a. Removald. Pinion Gear Replacementb.’ Disassemblye. Assemblyc. Cleaning and Inspectionf. InstallationINITIAL SETUP:Equipment Conditionl Direct clutch assembly removed.(See paragraph 5-1 7)• Control valve assembly removed.(See paragraph 5-7)l Governor assembly removed,(See paragraph 5-5)Too/s/Test Equipmentl Annular bearing inserter, J-21465-1l Drive handle, J-8092• Gear holding unit, J-21795-02l Inner seal protector, J-21363l 3/8 in, 12-point thin wail deep socketl Snapring pliersl Torque wrenchMaterials/Partsl TWO intermediate clutch piston sealsl Four oil seal ringsl Pinion package• Crocus cloth (Item 18, Appendix B)• Dry cleaning solvent(Item 23, Appendix B)l Hydraulic fluid (Item 40, Appendix B)l Petrolatum (Item 50, Appendix B)l Duct tape (Item 66, Appendix B)General Safety Instructions• Dry cleaning solvent is flammable andmust not be used near open flame.Use only in a well-ventilated area.• Compressed air used for cleaningpurposes should never exceed 30 psi(207 kPa).l When using drill, use only effectivechip-guarding and personnel protectiveequipment.a.REMOVALNOTEl If removing intermediate clutch, perform step 1.l If removing center support and gear unit assembly, perform steps 1-5.l If removing rear band, perform steps 1-8.l For ease of removal, transmission should be vertical with mainshaftfacing upward.l Clutch wave plate (4) has 2 “V” marks cut in outer circumference.1.Remove snapring (1), intermediate clutch backing plate (2), 3 intermediate clutch wave plates(3), 2 flat steel clutch plates (6), and clutch wave plate (4).5-106
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
