5-19. TRANSMISSION INTERMEDIATE CLUTCH, CENTER SUPPORT ASSEMBLY AND GEAR UNIT, AND REAR BAND MAINTENANCE (Cont)

5-19. TRANSMISSION INTERMEDIATE CLUTCH, CENTER SUPPORT ASSEMBLY AND GEAR UNIT, AND REAR BAND MAINTENANCE (Cont) - TM-9-2320-289-34_469

b. DISASSEMBLY - TM-9-2320-289-34_471

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
453

TM 9-2320-289-34 5-19. TRANSMISSION INTERMEDIATE CLUTCH, CENTER SUPPORT ASSEMBLY AND GEAR UNIT, AND REAR BAND MAINTENANCE (Con’t). l l NOTE Output shaft (13) should be covered with tape to prevent spline damage to case bushing when removing center support and gear unit assembly (14). Transmission holding fixture pivot bolt should be loosened slightly so that center support and gear unit assembly (14) does not bind when removed from transmission case (5). 5. Remove thrust washer (15) from output shaft (13) or transmission case (5). 6. Secure output shaft (13) and center support and gear unit assembly (14) in a soft-jawed vise with output shaft pointing down. Remove gear holding unit (11). NOTE Location of spacer (16) should be noted for installation. 7 . Remove selective washer (17) and spacer (16) from inside transmission case (5). TA50288 5-109

Privacy Statement
Press Release
Contact