Home
Download PDF
Order CD-ROM
Order in Print
4-14. DIRECTIONAL SIGNAL SWITCH REPLACEMENT (Cont) - TM-9-2320-289-34_359
CHAPTER 5 TRANSMISSION AND TRANSFER CASE MAINTENANCE
/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
338
339
340
341
342
343
344
345
346
347
348
TM 9-2320-289-34
4-14.
DIRECTIONAL SIGNAL SWITCH REPLACEMENT (Con’t).
5.
Install directional signal switch (6) with 4 mounting screws, Slide thrust washer, upper bearing
preload spring, and canceling cam onto steering shaft (7).
6 .
Install lock plate (5) and new upper shaft retainer (3) on steering shaft (7). Install lock plate
compressor
(2). Turn nut (1) until steering shaft groove is visible. Install upper shaft retainer in
groove, Remove lock plate
compressor
,
7 .
Snap lock plate (5) cover into position on lock plate.
FOLLOW-ON TASKS:
l
Install steering wheel and directional signal lever, (See TM 9-2320-289-20)
l
Install hazard warning control, (See TM 9-2320-289-20)
•
Check operation of directional signals.
TA50863
4-98
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business