d. ADJUSTMENT

5-3. VACUUM MODULATOR ASSEMBLY AND FILL TUBE ASSEMBLY REPLACEMENT

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
348

TM 9-2320-289-34 5-2. TRANSMISSION LINKAGE MAINTENANCE (Con’t), 3 . Install lever (19) assembly to transmission lever (10) with spring clip retainer (11). 4 . Install new insulator (4) and new bushing (2) to upper shift lever (3) if removed. Install rod (1) to upper shift lever with spring clip retainer (5). 5. Install swivel (16) on rod (1) and secure to lever (19) assembly with new wave washer (17) and bolt (18). DO NOT fully tighten bolt, d. ADJUSTMENT 1. Set transmission lever (10) in “N“ (Neutral) position by moving transmission lever clockwise until it stops , then counterclockwise 2 detents to “N“ (Neutral) position. Set transmission gearshift lever on steering column in “N“ (Neutral) position. 2. Hold rod (1) tightly in swivel (16) and tighten bolt (18) to 20 Ib.-ft. (27 N.m). 3. Place transmission gearshift lever on steering column in “P“ (Park) position and check the adjustment. Ensure that transmission gearshift lever on steering column goes into all positions and that engine starts in “ P“ (Park) or “N” (Neutral) positions only. If further adjustments are needed, loosen pivot bolt (18) and perform ADJUSTMENT, steps 1-3. FOLLOW-ON TASKS: l Remove chocks from wheels. TA50199 5 - 5

Privacy Statement
Press Release
Contact