TM 9-2320-289-344-8.BODY WIRING HARNESS REPLACEMENT (Con’t).7. Unsnap 1 clip (17) from frame (14),Disconnect body wiring harness (1)from right and left taillight wiringharness, and trailer wiring harness,Remove 2 nuts (21) and clips (22)from frame studs (20). Unsnap clipssecuring right and left blackoutmarkerh a r n e s s e s tobumperbracket. Pull taillight wiring harnessthrough holes in frame on right andleft sides,8.Lower body wiring harness from engine compartment. Attach a guide wire approximately 7 ft.(2. 1 m) long to bulkhead end of body wiring harness (1).9.Remove screw (25) and clip (24) from frame (14). Unsnap 4 clips (23) from frame andremove body wiring harness (1) from frame.10.Remove body wiring harness (1) by pulling harness from rear of truck, guiding harness throughopening in rear frame member. Remove harness from guide wire and leave guide wire in placein frame to aid in installation.b.INSTALLATION NOTEl If installing body wIlrlng harness (1) for all except Ml 009, perform steps3, 4, and 6 through 8.l If Installing body wiring harness (1) for Ml 009, perform steps 1, 2, 4, 5,7, and 8.l Ensure that all connectors are seated and locked in place as they areinstalled.1. Attach bulkhead end of body wiring harness (1) to guide wire at rear of vehicle. Guide wiringharness through frame and disconnect guide wire. Route wiring harness to bulkhead connectorin engine compartment,TA508294-62
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business