TM 9-2320-289-34
4-8.
BODY WIRING HARNESS REPLACEMENT.
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Equipment Condition
Materiels/Parts
l Both battery negative cables disconnected.
• One starwasher
(See TM 9-2320-289-20)
a . R E M O V AL
NOTE
l If removing body wiring harness
(1) from all except M1009,
perform steps 1-3, 5, and 6,
• If removing body wiring harness
(1) from Ml 009, perform steps
1, 2, 4, 5, and 7 through 10.
• Ensure that all leads are tagged
for Installation.
1 .
Remove bolt and disconnect body
wiring harness (1) at rear of fuse box
(3). Disconnect red lead at fuse box.
Depress sides of terminal “30” on
fuse box,
and disconnect pink
sending unit lead by pulling lead
toward front of connector.
2 .
Open clip (8) retaining body wiring
harness (1) to engine bulkhead (2).
Unsnap body wiring harness from
engine bulkhead,
3 .
Remove nut (5), open clip (6), and
pull body wiring harness (1) free. Pull
speedometer cable free if retained by
clip. Remove bolt (4) and retainer
plate (7) from inside cab if damaged.
4 .
Open adjustable retainer (9). Remove 5 bolts (10), 3 small clips (12), axle vent hose clip (13),
and large clip (11) from frame (14). Remove 2 nuts and ground wire, from right and left
blackout markers.
TA50827
4 - 6 0
