4-6. INSTRUMENT PANEL WIRING HARNESS AND EXTENSION REPLACEMENT (Cont)

4-6. INSTRUMENT PANEL WIRING HARNESS AND EXTENSION REPLACEMENT (Cont) - TM-9-2320-289-34_305

4-6. INSTRUMENT PANEL WIRING HARNESS AND EXTENSION REPLACEMENT (Cont) - TM-9-2320-289-34_307

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
289

TM 9-2320-289-34 4-6. INSTRUMENT PANEL WIRING HARNESS AND EXTENSION REPLACEMENT (Con’t). NOTE • Voltmeter lamp connector (8), “WATER-IN-FUEL” light connector (11), “WAIT” light connector (12), and instrument cluster connector (13) will be connected when instrument cluster is installed. • Ensure that all connectors are seated and locked in place as they are installed. 1. Install grommet (46) if removed. Push extension wiring harness (40) through grommet. Connect ambulance body accessory connectors (42). Snap extension wiring harness clips along frame (41), Install clamps (44) along frame with 5 screws (45). 2. If instrument panel wiring harness was replaced, install hazard flasher and all fuses. (See TM 9-2320-289-20) 3. Install blackout light relay (24) if removed. Snap instrument panel wiring harness clips along dash (6). Install insulator (5). TA50814 4-46

Privacy Statement
Press Release
Contact