3-33. ENGINE OIL PUMP MAINTENANCE - TM-9-2320-289-34

3-33. ENGINE OIL PUMP MAINTENANCE - TM-9-2320-289-34_180

c. CLEANING AND INSPECTION - TM-9-2320-289-34_182

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
164

TM 9-2320-289-34 3-33. ENGINE OIL PUMP MAINTENANCE. This task covers: a. Removal d. Assembly b. Disassembly e. Installation c. Cleaning and Inspection INITIAL SETUP: Equipment Condition Materials/Parts l Engine oil pan removed. l Dry cleaning solvent (See TM 9-2320-289-20) (Item 23, Appendix B) Too/s/Test Equipment General Safety Instructions • Torque wrench l l a. REMOVAL 1. Remove bolt (3) and remove oil pump (4) and shaft (1) from rear main bearing cap under engine block (5). Dry cleaning solvent is flammable and must not be used near open flame. Use only in a well-ventilated area. Compressed air used for cleaning purposes should never exceed 30 psi (207 kPa). b. DISASSEMBLY 1. Remove 4 cover bolts (9) and separate cover (10) from oil pump body (14). 2. Remove pin (13), spring (1 2), and oil pressure regulator valve (11). Remove oil plug (7) if damaged. TA50708 3-106 Change 2

Privacy Statement
Press Release
Contact