TM 9-2320-289-34
3-17.
CAMSHAFT BEARINGS INSTALLATION.
This task covers:
a. Installation
INITIAL SETUP:
Equipment Condition
Materials/Parts
l Camshaft bearings removed.
. One camshaft plug
(See paragraph 3-1 6)
l Lubricating oil (Item 49, Appendix B)
. Sealant (Item 56, Appendix B)
Too/s/Test Equipment
l Camshaft bearing puller, J-35178
a. INSTALLATION
NOTE
Seam in each camshaft bearing must be located in upper half of engine
face.
All camshaft bearings have an oil passage that must be installed at the
4 o’clock position. Front camshaft bearing has an additional oil passage
that must be positioned between 12 o’clock and 1 o’clock positions.
Notch in front camshaft bearing must be facing front of engine block (l).
1. Clean all sealant from rear of engine block (1) and camshaft bore.
T A 7 0 1 8 4 7 n
3-56
Change 2
