TM 9-2320-289-204-38.BATTERY CABLE MAINTENANCE (Con’t).d.CABLE INSTALLATION1.2.3.4.5.6.7.8.IfinstallingIfinstallingIfinstallingNOTEpositive cable (11), perform step 1.connector cable (9), perform steps 2 and 3.negative cable (3), perform steps 4-8.Install positive cable (11) on upper accessory wiring terminal board (15) stud with newIockwasher and nut.Install 3 retainers (16) on connector cable (9) if removed.NOTEDO NOT connect connector cable (9) to front battery (4)hold-down bracket was removed.Install connector cable (9) and leads on engine wiring harness blockInstall 2 clips (5) on negative cable (3), starter lead (20), and slavewith two screws (8), washers (7), and new locknuts (6) if removed.negative cable, starter lead, and slave receptacle cables if removed.terminal if(17) with nuts (18).receptacle cables (24)Install retainer (10) onInstall negative cable (3) on lower accessory wiring terminal board (15) stud with newIockwasher and nut.Install retaining nut (14) if removed. Install clip (13) on connector cable (9), negative cable(3), and slave receptacle cables (24). Install clip with bolt (12) if removed.Install starwasher, frame ground lead, and battery ground (25) with washer (1) and bolt (2).Install front battery hold-down bracket. (See paragraph 4-39)e.CABLE CONNECTIONNOTEIftruck is not equipped with winterization kits, perform steps 2-5.If installing positive cables, perform steps 2-5.If installing negative cables, perform steps 4 and 5.1.Install grommets (28) on any disconnected battery cable. Fit grommets into battery boxnotches as required.2.Install positive cable (11) clamp (22) on rear battery (19) positive (+) terminal. Tighten nut(21) and slide cover (23) over clamp.3.Install connector cable (9) clamp (22) on front battery (4) positive (+) terminal. Tighten nut(21) and slide cover (23) over clamp.4-76
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
