3-14. FUEL TANK SUPPLY AND RETURN HOSES AND PIPES REPLACEMENT (M1009)

3-14. FUEL TANK SUPPLY AND RETURN HOSES AND PIPES REPLACEMENT (M1009) (Cont) - TM-9-2320-289-20_174

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
152

TM 9-2320-289-20 3-14. FUEL TANK SUPPLY AND RETURN HOSES AND PIPES REPLACEMENT (M1009). This task covers: a. Removal b. Installation INITIAL SETUP: Equipment Condition MaterialslParts Both battery negative cables disconnected. One feed pipe (See paragraph 4-38) One return pipe Personnel Required General Safety Instructions MOS 63B (2) DO NOT perform this procedure near fire, flames, or sparks. Always wear goggles when working on underside of truck. a. REMOVAL 1. 2. 3. 4. 5. 6. WARNING Diesel fuel is flammable. DO NOT perform this procedure near fire, flames, or sparks. A fire extinguisher must be on hand in work area. Failure to follow this warning may result in serious injury or death. Always wear goggles when working on underside of truck. Fuel spillage can occur when disconnecting fuel lines. Failure to follow this warning may result in serious eye injury. NOTE Access to feed hose (8) and clamp (7) is difficult. It may be necessary to lower fuel tank to make step 1 easier to perform. (See paragraph 3-12) Remove clamp (7) and feed hose (8) from feed pipe (11). Remove screw (6) and 2 clips (5). Loosen clamp (22) and remove feed hose (23) from feed pipe (11). NOTE Rear feed pipe (11) must be cut before it can be removed. Remove 3 screws (2) and clips (1). Remove feed pipe (11). Discard feed pipe. Loosen clamp (24) and remove feed hose (23). Remove 3 screws (19), 3 clips (20), and remove feed pipe (21) from fitting (25). 3-40

Privacy Statement
Press Release
Contact