TM 9-2320-289-20
3-12.
FUEL TANK AND SHIELD MAINTENANCE (M1009) (Con’t).
15.
Install fill hose (47) to fill pipe assembly (30) with clamp (48).
16.
Install vent hose (32) to fill pipe assembly (30) with clamp (31).
17.
Position sending unit drain hose (45) and drain pipe (40) along frame. DO NOT install at this
time.
18.
Connect 2 sending unit hoses (37) to ends of pipes and secure with 2 clamps (38).
19.
Install sending unit wire (29) to sending unit (15).
20.
Position ground wire (17) over top of frame. DO NOT connect at this
21.
Raise fuel tank (26) into position.
22.
Insert 2 strap assemblies (24) through holes in rear crossmember.
Steps 23, 27, and 28 are
23.
Secure 2 strap assemblies (24) and
NOTE
easier to perform with endgate
time.
down.
2 wiring harness tabs with washers (19) and nuts (18).
TA49789
3-29
