TM 9-2320-289-20Table 2-4. Electrical Troubleshooting (Con’t)MALFUNCTIONTEST OR INSPECTIONCORRECTIVE ACTION39. STOPLIGHTS WILL NOT TURN OFFStep 1.Disconnect connector from stoplight switch,If lights go out, reconnect connector and adjust stoplight switch for propercontact with brake pedal. (See paragraph 4-16, INSTALLATION) If lightsremain on, replace switch (See paragraph 4-16)If lights remain on after disconnecting connector, trace circuit. (See wiringdiagram F-14, F-15, or F-17)40. TURN SIGNALS INOPERATIVE (HAZARD WARNING LIGHTS OPERATE)Step 1.Remove turn signal flasher. (See paragraph 4-12) Using jumper wire, connect fusebox terminals where flasher was installed. Lights should turn on, but not flash.If lights turn on, replace flasher.If lights do not turn on, trace circuit. (See wiring diagram F-13 or F-16)41. TURN SIGNALS LIGHT BUT DO NOT FLASHStep 1.Check appropriate marker light or parking light bulb. (See paragraph 4-26 or 4-27)Replace bulb if burned out.Step 2.Remove turn signal flasher. (See paragraph 4-12) Using jumper wire, connect fusebox terminals where flasher was installed. Lights should turn on, but not flash.If lights turn on, replace flasher.If lights do not turn on, trace circuit. (See wiring diagram F-13 or F-16)STARTING SYSTEM42. ENGINE WILL NOT CRANK (NO AUDIBLE CLICK FROM STARTER SOLENOID)Step 1.Check 20 amp ignition fuse. (See paragraph 4-12)Replace fuse if burned out.Step 2.Perform Electrical Troubleshooting malfunction #5.2-74
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
