TM 9-2320-280-34
Section II. ILLUSTRATED MANUFACTURING INSTRUCTIONS (Cont'd)
INSTRUCTIONS:
1.
Fabricate from screw, NSN 5305-00-709-8540.
2.
Cut off head of screw.
3.
Round off edge of non-threaded end as shown above.
4.
Cut a slit approximately 1/16 in. wide and 1/8 in. deep in non-threaded end as shown above.
5.
Remove any burrs after cutting.
'
INSTRUCTIONS:
1.
Fabricate from screw, NSN 5306-00-226-4833.
2.
Cut off head of screw.
3.
Round off edge of non-threaded end as shown above.
4.
Cut a slit approximately 1/16 in. wide and 1/8 in. deep in non-threaded end as shown above.
5.
Remove any burrs after cutting.
C-2
