TM 9-2320-280-34
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
Equipment Condition
General mechanic's tool kit:
Hood raised and secured (front mounts only)
automotive (Appendix G, Item 1)
(TM 9-2320-280-10).
Manual References
Maintenance Level
TM 9-2320-280-10
General support
TM 9-2320-280-24P
NOTE
Removal and installation procedures for intermediate and rear
body mounts are identical.
On front body mounts, capscrew is inserted down through upper
cushion.
This procedure covers the left intermediate body mount.
a. Removal
1.
Remove nut (2), washer (1), capscrew (7), washer (8), and spacer (9) from sleeve (4), upper
cushion (5), lower cushion (10), body bracket (3), and frame bracket (6).
2.
Place jack under body reinforcements adjacent to body mount to be removed.
3.
Raise the body far enough to separate the upper cushion (5) from lower cushion (10) and remove
sleeve (4), upper cushion (5), and lower cushion (10).
b. Installation
1.
Install lower cushion (10), sleeve (4), and upper cushion (5) between body bracket (3) and frame
bracket (6).
2.
Lower body and align lower cushion (10), sleeve (4), upper cushion (5), and body bracket (3).
Install with spacer (9), washer (8), capscrew (7), washer (1), and nut (2). Tighten nut (2)
to 90 lb-ft (122 Nm).
Change 2
