TM 9-2320-280-34
17-30. TRANSMISSION ASSEMBLY FROM SUBASSEMBLIES(4L80-E) (Cont'd)
e. Intermediate Clutch Assembly
NOTE
Soak all clutch plates in transmission fluid for at least three
minutes before assembly.
Wave plate is used on 1997-1998 transmissions only.
1.
Install wave plate (5.1), four clutch plates (3), plate assemblies (5), and backing plate (2) on
transmission case (4) starting with a clutch plate (3), then alternating plate assemblies (5) with
clutch plates (3) and ending with flat side of backing plate (2) facing down.
2.
Secure backing plate (2) to transmission case (4) with snapring (1). Position snapring gap at
nine o'clock position.
3.
Measure gap between snapring (1) and backing plate (2). Gap should be 0.040-0.107 in.
(1.02-2.72 mm).
1995-1996
1997-1998
17-136
Change 1
