TM 9-2320-280-34
17-30. TRANSMISSION ASSEMBLY FROM SUBASSEMBLIES (4L80-E) (Cont'd)
3.
Install return spring (2) with square hook end under pawl (1) and round end on stud (15) in
transmission case (11).
4.
Position actuator (5) in detent lever (7) over pawl (1) in transmission case (11).
5.
Install gasket (10) in transmission case (11).
6.
Coat manual shaft (9) with transmission fluid and install shaft (9) on transmission case (11)
through seal (10) and detent lever (7).
7.
Secure manual shaft (9) to detent lever (7) with nut (6).
8.
Adjust position of manual shaft (9) in transmission case (11) and secure manual shaft (9) with
retaining pin (8). Tighten nut (6) to 18 lb-ft (24 Nm).
9.
Install slide bracket (3) over actuator (5) and transmission case (11) with two capscrews (4).
Change 2
17-131
