TM 9-2320-280-34
6-9. BODY WIRING HARNESS REPLACEMENT (Cont'd)
43.
Install trailer connector (1) in bracket (2) with four capscrews (8) and locknuts (7).
44.
Install harness (3) on body (6) with five clamps (5) and screws (4).
45.
Apply antiseize compound to harness ground lead 95B (11) and install on buss bar (10) with
washer (12) and capscrew (13).
46.
Apply antiseize compound to harness ground lead 95C (22) and install on left rear side marker
light (19) with nut (21) and screw (20).
47.
Connect harness leads 21C (38), 22-461B (37), 23B (36), and 24B (35) to left rear composite light (9).
NOTE
Perform step 48 for M1035, M1035A1 and M1035A2 only.
48.
Connect harness lead 467E (32) to backup light (39). Install ground lead 95D (18) to stud (31) with
lockwasher (17) and nut (16).
49.
Connect harness lead 489A (23) to left rear side marker light (19).
50.
Install harness (3) on shield (15) with two clamps (27), capscrews (14), and assembled locknuts (26).
51.
Install shield (15) on body (6) with two lockwashers (25) and screws (24).
52.
Install harness (3) on body (6) with clamp (28), capscrew (29), and assembled locknut (30).
53.
Install harness (3) on body (6) with two clamps (34) and screws (33).
NOTE
Perform steps 54 and 55 for 6.5 L only.
54.
Install body harness (45) on dipstick support bracket (44) with screw (43), clamp (46), and nut (47).
55.
Connect two leads 458A (40) to leads 458c (42) and 458d (41).
56.
Install harness (3) on body (6) with three clamps (48) and screws (54).
57.
Install harness (3) on body (6) with three clamps (52) and screws (53).
58.
Connect harness leads 28A (51) and 58C (50) to fuel tank jumper harness (49).
6-106
Change 2
