TM 9-2320-280-34
6-3.2. 100 AMPERE ALTERNATOR (12342944) TESTING AND REPAIR (Cont'd)
NOTE
Prior to removal, tag leads for installation.
10.
Remove six nuts (1), field leads (2), and washers (3) from studs (4) on front housing assembly (7).
11.
Remove six nuts (8), phase leads (5), and washers (3) from diodes (6) on front housing assembly (7).
12.
Remove nine locknuts (9) from front housing (7) and stator (10). Discard locknuts (9).
13.
Remove front housing (7) from stator shell (10) by tapping lightly with a soft-faced mallet.
14.
Remove shaft retaining ring (11) from core and shaft assembly (12).
WARNING
Always support alternator core and shaft assembly during removal.
Failure to do so may cause injury to personnel or equipment damage.
15.
Use press to remove core and shaft assembly (12) from front bearing (13) and front housing (7).
16.
Remove front (14) and rear (16) retaining rings from front housing (7).
17.
Use press to remove front bearing (15) from front housing (7).
18.
Remove three screws (21), lockwashers (20), and washers (19) from front rotor assembly (18) and
core and shaft assembly (12). Discard lockwashers (20).
19.
Use three 10-32 x 2-in. long machine screws (17) as jacks in threaded holes on end plate of front rotor
assembly (18). Gradually tighten screws to remove front rotor assembly (18) from core and shaft
assembly (12).
Change 2
