TM 9-2320-280-34
3-22. ENGINE REMOVAL (6.2 L AND 6.5 L [DETUNED]) (Cont'd)
NOTE
Prior to removal, tag leads for installation.
69.
Remove nut (29), lockwasher (28), washer (27), lead 3B (26), and ground strap (25) from ground
stud (24). Discard lockwasher (28).
70.
Slide back rubber boot (30) and remove nut (1), lockwasher (2), washer (3), fuse link (4) insulator
washer (31), alternator positive cable (5), and washer (6) from positive stud (7). Discard
lockwasher (2).
71.
Loosen capscrew (12) and (14) on alternator adjusting bracket (9) securing alternator (20) to
alternator mounting bracket (19) and support bracket (18).
72.
Remove three drivebelts (8) from alternator pulley (23).
WARNING
Alternator must be supported during removal and installation.
Failure to support alternator may cause injury to personnel or
damage to equipment.
73.
Remove capscrew (12), lockwasher (11), and washer (10) from alternator (20) and adjusting
bracket (9). Discard lockwasher (11).
74.
Remove capscrew (14), washer (13), and alternator adjusting bracket (9) from
mounting bracket (19).
NOTE
Perform step 76 for vehicles with new alternator support
bracket configuration.
In some cases, a thru-bolt and nut may be present on mounting
bracket instead of standard capscrews and washers.
75.
Remove two capscrews (15), lockwashers (16), and washers (17) from alternator (20) and support
bracket (18) and mounting bracket (19). Discard lockwashers (16).
76.
Remove two capscrews (15), lockwashers (16), washers (17), and spacer (22) securing
alternator (20), power steering lines bracket (21), and support bracket (18) to mounting bracket
(19). Discard lockwashers (16).
77.
Remove alternator (20).
3-62
Change 2
