TM 9-2320-280-34
This task covers:
a. Removal
c. Assembly
b. Disassembly
d. Installation
INITIAL SETUP:
T__ls
_oo_
Manual_R_fe____es
______ _e _ renc __
General mechanic's tool kit:
TM 9-2320-280-20
automotive (Appendix G, Item 1)
TM 9-2320-280-24P
S__ci______s
_pe _ al Tool
E___pm_____ondi_i__
_ qui __ ent C ___ t on
Crowfoot, 5/8 in. (Appendix G, Item 110)
Fuel pump removed (right engine mount only)
Torque adapter, 9/16 in. (Appendix G, Item 106)
(TM 9-2320-280-20).
Torque adapter, 3/4 in. (Appendix G, Item 107)
Right engine splash shield removed
Adapter, 3/8-1/2 in. (Appendix G, Item 108)
(TM 9-2320-280-20).
Engine lifting sling (Appendix G, Item 22)
Engine access cover removed (TM 9-2320-280-20).
Front propeller shaft removed (left engine
Mat__ials/____s
er___ Part _
___
mount only) (TM 9-2320-280-20).
Five lockwashers (Appendix E, Item 104)
Glow plug controller removed (TM 9-2320-280-20).
Ten locknuts (Appendix E, Item 65)
Air horn support and engine lift bracket
Four locknuts (Appendix E, Item 63)
removed (TM 9-2320-280-20).
Antiseize compound (Appendix B, Item 7)
Ge___al_Safe_y ___tr___i___
__ ner_ ___ t_ Ins _ uct ons
P_rsonne___equi__d
e_____ l R ___ re _
_
Direct all personnel to stand clear during hoisting
One mechanic
operation.
One assistant
Mai__enance_L_vel
___ nt _____ _e __
Direct support
a. Removal
NOTE
Left and right engine mounts are removed basically the same
except right hand engine mounts have a starter support bracket.
1.
Remove two locknuts (9) and washers (10) from insulator (11) on engine mount bracket (8). Discard
locknuts (9).
NOTE
Perform steps 2 and 3 for right engine mount only.
2.
Loosen nut (12) securing starter (13) to starter support bracket (1).
NOTE
Proceed to step 4 for vehicles with new support bracket configuration.
3.
Remove two capscrews (3), lockwashers (2), and starter support bracket (1) from starter (13) and
right engine mount (4). Discard lockwashers (2).
4.
Remove three capscrews (7) and lockwashers (6) from right engine mount (4) and cylinder block (5).
Discard lockwashers (6).
5.
Remove capscrew (14) and grounds 3A (15) and 58A (16) from left cylinder head (17).
6.
Remove four locknuts (22), washers (21), and capscrews (19) from radiator supports (18) and airlift
brackets (20). Discard locknuts (22).
Change 2
