TM 9-2320-280-34
1-8. MANDATORY REPLACEMENT PARTS
The maintenance instructions contained herein make reference to removing and discarding piece parts such
as: gaskets, lockwasher, cotter pins, O-ring seals, etc.; these items should be considered mandatory
replacement items and replaced with new parts during assembly/installation.
Section II. EQUIPMENT DESCRIPTION AND DATA
1-9. EQUIPMENT DESCRIPTION
Detailed descriptions covering the 1-1/4 ton, 4X4, M998 series vehicles are in TM 9-2320-280-10 and
TM 9-2320-280-20.
1-10. TABULATED DATA
Tabulated data is listed in table 1-1. This information includes only that data applicable to direct support
and general support maintenance. Information not covered can be found in TM 9-2815-237-34, TM 9-2320-
280-20, TM 9-2320-280-10.
NOTE
Standard and metric measurements will be used in this table and
throughout the manual. A list of their abbreviations is provided below.
TABULATED DATA ABBREVIATIONS
MEASUREMENT
ABBREVIATION
MEASUREMENT
ABBREVIATION
Pint ..................................................................pt
Celsius ............................ ................................. C
Quart ................................ ...............................qt
Liter ............................... ...................................1
Gallon ..............................................................gal.
Centimeter ........................ .............................cm
Inch .............................. ...................................in.
Kilometers Per Hour ...................................... kph
Pound ............................... ...............................lb
KiloPascal ......................... ........................... kPa
Miles Per Hour .................................................mph
Maximum .....................................................max
Pound Per Square Inch ....................................psi
Minimum .......................................................min
Revolutions Per Minute ....................................rpm
Kilogram ......................... ................................ kg
Pound-Feet ......................................................lb-ft
Newton Meter ............................................... N.m
Gallons Per Minute ................... .......................gpm
Millimeter ........................ ............................. mm
Volt ..................................................................V
Ampere ........................... ................................. A
Horsepower .......................... ...........................hp
Liters Per Minute ...........................................Ipm
Fahrenheit ............................ ...........................F
KiloWatt .......................... .............................. kW
