*TB 9-4910-492-30
DEPARTMENT
OF
THE
ARMY
TECHNICAL
BULLETIN
HOISTING
UNIT
TRUCK
MOUNTING:
ORGANIZATIONAL
MAINTENANCE,
SET
NO.
7
(4910-754-0652)
INSTALLATION IN ONE 2-1 / 2-TON,
6X6 CARGO TRUCK, M34 OR M35
Headquarters,
Department of the Army,
Washington,
D.C.
27 November 1970
This bulletin is current to 7 October 1970.
1. General a. Instructions contained in this
characteristics of the body are retained. All hard-
w a r e extending through the floor of the truck
bulletin are to be used as a guide for installation of
should have outer parts covered with undercoating
H o i s t i n g Unit Truck Mounting, Organizational
similar to that used on the underside of vehicles.
Maintenance, Set No. 7, 4910-754-0652, in one
2 - Ton, 6 x 6 Cargo Truck, M34 or M35.
C a r e should be taken that holes drilled into the
floor do not penetrate the frame or cross members
b. These instructions are to be followed as
of the vehicle.
p r e s c r i b e d in most instances. However, slight
v a r i a t i o n s to the installation may be made at the
2. Installation of Hoisting Unit. a. T h e f l o o r
discretion of the Officer in charge.
plan for the truck with each item in its designated
c. A complete list of items contained in this set is
spot is shown in figure 1. Right-side view of sup-
i n c l u d e d in SC 4910-95-CL-A51.
e r s t r u c t u r e is shown in figure 2. Superstructure,
Hoist is shown in figure 3. Items to be mounted are
h o l e s through the body to insure the waterproof
listed in table l.
1
