MWO 9-2320-242-35
(i) Tighten outboard seat belt attachment screw (MS90728-110) and nut (MS51943-39) to 100-110 lbs.
ft. (figure 6).
(j) Install inboard seat belt to floor using MS90728-113 screw, MS27183-18 washer and MS51943-39
nut. Tighten screw to 100-110 lbs. ft.. (figure 6).
(k) Repeat procedures for the driver's side using 12370472-2 as a template. (Passenger's side is shown
as typical, except for passenger's removable access floor panel).
(3) Installing Seat Belt Warning Stencil.
(a) Use 1/2" Stencil Kit (NSN 7520-00-205-1760) to compose the Seat Belt Warning. (figure 7)
(b) Apply stencil using lusterless yellow or appropriate unit mission requirement colors. (figure 8)
Figure 7. Seat Belt Warning
Figure 8. Typical Stencil Pattern
10
