TM 9-2320-289-34
3-6.
ROCKER ARM AND ROCKER ARM COVER REMOVAL AND REPAIR.
This task covers:
a. Removal
c. Cleaning and Inspection
b. Disassembly
d. Assembly
INITIAL SETUP:
Equipment Condition
MaterialslParts
l Fuel injector pipes removed.
(See paragraph 3-5)
General Safety Instructions
l Dry cleaning solvent is
well-ventilated area.
flammable and must not be
• Cotter pins (as needed)
• Rocker arm retainers (as needed)
• Dry cleaning solvent
(Item 23, Appendix B)
used near open flame. Use only in a
a. REMOVAL
NOTE
• IF removing right rocker arm cover (3), perform steps 1-4.
• iF removing left rocker arm cover (8), perform steps 2-4.
1. Remove 2 nuts (2) and disconnect 2 vacuum line clamps (1) from studs (4) securing right
rocker arm cover (3).
2.
Disconnect wiring harness from wiring harness clips along rocker arm cover (3 or 8). If
removing left rocker arm cover (8), remove wiring harness bracket.
3.
Remove 2 nuts (6) and fuel injector pipe bracket (5).
TA60626
3 - 1 4
