TM 9-2320-289-3410-11. CARGO BODY PICKUP BOX MAINTENANCE (Con’t).c. ASSEMBLY WARNINGUse caution when handling sheet metal. Sheet metal has numerous sharpedges and splinters. Failure to follow this warning may result in injury topersonnel,NOTE• Left and right body side panels and wheel house panels are assembledthe same way.l If installing wheel house panel, perform steps 3, 4, 6, and 12.• If installing body side panel, perform steps 1, 2, 4, 5, 7, and9 through 12.l If installing front panel, perform steps 8, 9, and 12.l Perform steps 0.1 through 0.6 for M1028A2 and M1028A3.. If installing rear fender (31 .4), perform steps 0.1 through 0,5.0.1.Install 6 brackets (31 .3) to rear fender (31.4) with 6 bolts (31 .2).0.2. Check rear fender (31 .4) fit and hole alinement with side panel (11).NOTEIf necessary, adjust holes in side panel with round file and prime holes.0.3. Start studs in brackets (31 .3) first and roll rear fender (31.4) into position on side panel (11).NOTEIt is permissible to spread inner and outer panels of side panel (11) tofacilitate installation of nuts (31 .3).0.4. Apply a bead of sealant to rear fender edge and install rear fender (31 .4) to side panel (11) with12 nuts (31.3).0.5. Using rear fender as a guide, drill 2 holes at front and rear of rear fender (31 .4), using 29/64 in.(1 1.50 mm) drill bit. These holes are not shown on template. Apply primer to holes.0.6. Install rear fender wiring harness. (See paragraph 4-9.1)10-42.2Change 2
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
