TM 9-2320-289-346-8.FRONT AXLE DIFFERENTIAL MAINTENANCE (ALL EXCEPT M1009) (Con’t).4.5.Loosen tension from clutch compressor (18) and install 2 pinion gears (15) by rotatingdifferential case (7) assembly, Tighten clutch compressor and install 2 thrust washers (17)between pinion gears and differential case assembly. Remove clutch compressor.Install differential case (7) assemblyon axle shaft (14) in vise. Install 2side gears (16) and thrust washers(17). Rotate side gears to install 2pinion gears (15) and thrust washers.NOTEEnsure that pinion gear (15) and thrust washer (17) holes are alined withdifferential case (7) assembly holes.6 .Install pinion shaft (12) with Iockpin(13) hole onshaft alined withdifferential case (7) assembly Iockpinhole.NOTEl Perform step 7 only if workingon M1028, M1028A1, or M1031.l Tape used in step 7 indicatesdepth required to install Iockpin(13).7.Place a piece of tape 1 3/4 in.(4.61 5 mm) from end of punch.8 .Install Iockpin (13) through differentialcase (7) assembly into pinion shaft(12).TA505436-49
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business