TM 9-2320-289-2011-17. ENGINE COOLANT HEATER WIRING HARNESS REPLACEMENT.This task covers:a. Removalb. InstallationINITIAL SETUP:Equipment ConditionMaterials/parts• Both battery negative cables disconnected.• Tie-down straps (Item 44, Appendix C)(See paragraph 4-38)a.REMOVALNOTE• If removing relay (10), perform step 3.• Tag all leads and connectors for installation.1.Disconnect wiring harness connector( 5 ) f r o m e n g i n e c o o l a n t h e a t e rt h e r m o s t a t ( 4 ) . R e m o v e e n g i necoolant heater (1) cover anddisconnect wiring harness (2) fromengine coolant heater, Disconnectwiring harness connector (6) fromcab heater connector (7). Removeand discard tie-down straps fromwiring harness.2.Disconnect wiring harness (2) from cab heater control panel assembly (8). Loosen nut onstrap (9) and disconnect wiring harness.3.Remove relay (10) and disconnect from wiring harness (2).4.Remove wiring harness (2) and grommet (3) from bulkhead. Retain grommet for installation ifnot damaged.TA5008911-62
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business