TM 9-2320-289-20 tern No. 6 7 8 Table 2-1. Unit Level Preventive Maintenance Checks and Services for CUCV’ Interval Annual Annual Annual Item To Be Inspected Front Wheel Bearings and Hubs Continued Engine Starter Procedure a.  Remove   locking   hubs   (see   para- graph 8-3). Clean and inspect for dam- age. b. Remove, clean, dry, and inspect front wheel  bearings. c.  Repack  front  wheel  bearings  with GAA and install. cl. Install locking hubs (see paragraph 8-3). NOTE The rear wheel bearings cm all except M1009 do not require routine repack- ing of the rear wheel bearings. They are  Iubricated  by  the  rear  differential fluid. They should only require repacting if the  drum  is  turned  during  brake  re- placement or if contaminated after dis- assembly. Inspect for loose, cracked, or damaged engine mounts, expansion plugs, crank- shaft pulley, and torsion damper. If en- gine  mount  retaining  bolts  are  loose, tighten to 85 ft-lbs (115 N.m). If any of these components are cracked or dam- aged,   notify   your   supervisor. a. Inspect starter mounting bolts to en- sure that none are loose or missing. If loose, tighten to 33 ft-lbs (45 N.m). b. Inspect starter wiring connections for looseness. Not  Mission Capable If: a.  Any  damage  that will   prevent   opera- tion. Engine mounts cracked,    damaged. Any damage that will prevent operation. Class Ill leak. a.  Mounting bolt missing,   broken   or loose. b. Stud nut loose. 2-24.1